Master Stop Tape Installation Instructions

• Testing of adhesive before installation is suggested.
  
  
• Surface temperature must be above 55°.
  
  
• Apply to smooth surface. Repair application area by filling in any cracks and pits. Seal porous surfaces. DO NOT apply over grout lines.
  
  
• Clean surface using industrial cleaner. Remove any oils, dirt, and flaking paint.
  
  
• Flush surface to remove any soap residue.
  
  
• Allow ample dry time.
  
  
• Cut to size. Rounding corners is suggested.
  
  
• Peel off paper backing. Keeping fingers off adhesive.
  
  
• Position and Press in to place, pushing from the center out to the edges to remove any air bubbles. For enhanced bond use a rubber hand roller.
  
  
• Ready for immediate use.
  
  
• Surface can be cleaned using mild floor cleaner as directed.